Operating The Generator; Basic Notes On Operation - Dometic TEC40D Notice D'utilisation

Masquer les pouces Voir aussi pour TEC40D:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
TEC40D
8

Operating the generator

A
NOTICE!
Do not run the generator over 70 % of the maximum constant out-
put for the first 50 operating hours (run-in phase).
I
NOTE
Run the generator at a maximum of approx. 75 % of the maximum
continuous load after the run-in phase.
By doing this you can prolong the service life of the generator and
maximise its efficiency.
8.1

Basic notes on operation

!
CAUTION! Beware of injury
Do not insert your fingers or objects into the air nozzles or the
intake grille.
Please note the following basic information:
 When operating the generator at low temperatures (< 0 °C) you have to
use winter diesel fuel or you have to add a percentage of petrol to the
diesel oil according to the following table:
Ambient Temperature
–10 to 0 °C
–15 to –10 °C
–20 to –15 °C
 Always check the oil level before use (chapter "Checking the oil level" on
page 19).
 Even small overloads in the long-run will cause the generator to stop.
 Leave the generator running for a few minutes after use without any con-
sumers before stopping it.
 Abrupt braking, accelerating and driving round bends in the vehicle can
cause problems in the generator's pump system and lead to unwanted
shutdown.
 If you are not using your generator for a longer period of time, start it up
at least every 10 days and leave it running for 15 minutes or more.
EN
Summer diesel
20 %
30 %
30 %
Operating the generator
Winter diesel
20 %
15

Publicité

Table des Matières
loading

Table des Matières