Beurer BM 28 Mode D'emploi page 23

• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury
Setting the hour format, date and time
It is essential to set the date and time. Otherwise, you will
not be able to save your measured values correctly with a
date and time and access them again later.
To set the date and time, proceed as follows:
• Insert the batteries, or press and hold the setting button
SET for at least 5 seconds if the batteries have already
been inserted.
• Select 12h or 24h mode using the function buttons -/+.
Press SET to confirm. The year display will start to flash.
Set the year with the function buttons -/+ and confirm with
SET.
• Set the month, day, hour and minute and confirm each
with the setting button SET.
• The blood pressure monitor switches itself off automatically.
Set alarm
You can set 2 different alarm times to remind yourself to
take the measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultaneous-
ly for 5 seconds.
• Alarm 1 is shown in the display, „on" or „off" flashes
at the same time. With the function buttons -/+, choose
whether alarm 1 should be activated („on" flashes) or
deactivated („off" flashes) and confirm with the setting
button SET.
• If alarm 1 is deactivated („off"), you automatically
switch to setting alarm 2
• If alarm 1 is activated, the hours flash on the display.
Select the desired hour using the function buttons -/+ and
confirm with SET. The minutes flash on the display. Select
the desired minute using the function buttons -/+ and
confirm with SET.
• Alarm 2 is shown in the display, „on" or „off" flashes
at the same time. To set, proceed as for alarm 1
blood pressure monitor switches itself off automatically.
Operation with the mains adapter
You can also operate this device with a mains adapter.
When doing so, there must not be any batteries in the bat-
tery compartment.
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains
adapter described here.
• Insert the mains adapter into the connection provided for
this purpose on the blood pressure monitor. The mains
23
.
. The