Installation Instructions - SciCan HydriM L110w Manuel De L'utilisateur

4. installation instructions

To open the wash chamber door, plug in the unit, turn
it on and press the unlock symbol. Alternatively,
remove the screw in the kickplate and pull the ring.
Tools and supplies required for installation:
• Slot screwdriver
Specifications:
Voltage: 208 – 240 V
Frequency: 60 Hz
Rated load: 2 kW
Circuit
breaker: 15 A
per phase
Utility Hook-ups
Hose / Length /
Cord diameter
Hot inlet 1.9 m / 6 ft.
3/4"
Cold inlet
1.9 m / 6 ft.
3/4"
drain
1.5 m / 5 ft.
3/4"
Electrical
1.8 m
AWG 14-3
power cord
• Channel locks
Height: 850 mm / 33.5"
Width: 600 mm / 23.75"
Depth: 600 mm / 23.75"
Depth with
door open: 1200 mm / 47"
Weight: 80 kg / 176 lbs
Running Noise: 60 dBA
Max. distance Water
distance from Pressure
inlet / drain
1.5 m / 5 ft. 1-10 bar /
14.5- 1 45 psi
1.5 m / 5 ft. 1-10 bar /
14.5- 1 45 psi
—
—
cold water inlet
installation:
If the Hydrim is installed in a Sterilization Center,
the manufacturer of the Sterilization Center should
allow a 10mm / 1/2" space at the top, back and
both sides of the Hydrim. This will facilitate instal-
lation, and service access to the Hydrim.
Do not move the Hydrim into place by maneuvering
the open wash chamber door. This may cause to
door to become misaligned and leak.
Levelling the Hydrim:
The unit is standing on three supports: rollers
(wheels) at the back and two legs at the front.
1. Remove the front kickplate. Push the Hydrim into
Shut
2. Adjust the front legs as required until the Hydrim
-off
valve
3. The rear two legs are used only if the floor is
Yes
4. T uck the strap under the machine before
Yes
— —
— —
hot water inlet hose
4
For safety reasons, do not install the
Hydrim without the top cover.
place while lifting the strap at the front to allow
the unit to roll on the rollers.
is level.
uneven or cannot provide support to the rollers.
replacing the kickplate, so as not to interfere
with the exhaust air vents.
drain hose rollers