Maintaining Fluid Levels; Reading Water Quality; Using On-Screen Instructions - SciCan STATIM 2000 G4 Manuel De L'utilisateur

9 Maintaining your STATIM

9.7 Maintaining Fluid Levels

1. The water reservoir level is continually monitored by your STATIM. If the reservoir is low, a red X will
appear on the water icon
confirm that it is a water level issue and not a water quality issue.
2. If the reservoir is low, a
3. To fill the reservoir, use only steam-processed distilled water containing less than 5 ppm total
dissolved solids (having conductivity of less than 10 μS / cm). Remove the cap from the top of the
unit and fill the reservoir. We recommend using a funnel to minimize spills. Each time you refill the
reservoir, empty the waste bottle and refill with water to the MIN line. Empty the waste bottle often
to avoid unpleasant odors and discoloration of the contents. (A low-level chlorine-free disinfectant,
prepared according to the manufacturer's instructions, may be added to the waste bottle to remedy
this situation).

9.8 Reading Water Quality

1. The water quality is continually monitored by your STATIM to ensure that only steam-process distilled
water is being used. If the water quality is beyond the tolerances specified above, a red X will appear
on the water icon
that it is a water quality issue and not a water level issue.
2. If the water quality not suitable,
3. Using the drain tube (see Section Priming the Pump, Figure 6) empty the contents of the reservoir into
the water container and replace with steam-process distilled water containing less than 5 ppm total
dissolved solids (having conductivity of less than 10 μS / cm).

9.9 Using On-Screen Instructions

The STATIM G4 on-screen help instruction can be viewed by following these steps:
1.
2. Scroll to Instructions
3. Choose the Instructions you would like to view and select.
of the cycle select screen. Press the icon to go to the next screen to
will appear next to WATER LEVEL.
of the cycle select screen. Press the icon to go to the next screen to confirm
will appear next to micro S. and parts per million values.
and select.
Page 44