Recalling A Wheel Profi Le From The Memory - John Bean B800 Manuel D'utilisation

3
78
5-32
4
4-11
4-12
Operation "MANUAL MODE"
5.14.1 Saving a Wheel Profi le
Up to 9 wheel profi les can be saved.
— Clamp the wheel you wish to save the profi le of.
— Set and acquire all the wheel data, including the
number of spokes if an Alu P is required.
— In the RIM DATA ENTRY screen press the
"SPECIAL" key (Fig. 5-32).
The WHEEL PROFILES screen is displayed (Fig.
4-11).
The current wheel profi le data are highlighted in a line
on its own at the bottom of the page.
— In the 9 position list, use the Scroll command to
choose the current profi le registration position.
— Press key (3, Fig. 4-11) to save data.
The data are now saved permanently in the chosen
position and can be recalled when required.
Note: If the profi le is overwritten with other data it is
no longer shown in the list.
5.14.2 Recalling a Wheel Profi le from the
memory
— Clamp the wheel to the balancer.
— In the RIM DATA ENTRY screen press the
"SPECIAL" key (Fig. 5-32).
The WHEEL PROFILES screen is displayed (Fig.
4-11).
— Type on one of the nine lines to select the profi le
indicated for the wheel being processed.
— Press key (4, Fig. 4-11) to apply the selection.
The RIM DATA ENTRY screen will open (Fig. 4-12)
and show the data recalled.
— Check that the settings in the Indications Field and
Status Bar panel are correct.
The machine is now ready to proceed with the
F
measuring run ( 5.13).