Table des Matières
Publicité
8
106
5-63
5-64
5-65
5-66
Operation
Message E9
Message E9 means that at least one error has occurred
during the optimisation cycle (System messages
7.1).
— Abort the optimisation program by pressing the
STOP key and, if desired, start optimisation once
again.
Figure 5-63 OPTIMISATION "12"
(fourth measuring run with tyre)
— Clamp the wheel.
— Position the valve so that it is exactly perpendicular
to and above the chuck.
— Confi rm the valve position by pressing key 8.
The OPTIMISATION "13" screen appears (Fig. 5-64).
Figure 5-64 OPTIMISATION "13"
START is signalled on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The BALANCING screen appears (Fig. 5-65).
Finish weight Optimisation
Figure 5-65 BALANCING
— Balance the wheel according to the readings.
Fig. 5-66
If the silent wheel running conditions are optimal, the
following codes can be displayed:
H0
Silent wheel running conditions cannot be
improved by optimisation.
H1 Further optimisation not recommended but possible.
H2 Weight minimisation is recommended, optimisation
can achieve no further improvement.
F
Publicité
Table des Matières
