John Bean B800 Manuel D'utilisation page 72

Operation "MANUAL MODE"
........
5.12 Wheel measuring run (in
Manual)
1
This function is retrieved with the key (1, Fig. 5-27)
available in the main Menu.
F
– Check the wheel is clamped correctly ( 5.2).
F
– Select the Type of Vehicle ( 5.6.2).
F
– Enter the rim dimension parameters ( 5.13).
5-27
If more than one wheel of the same type needs to be
balanced (the same nominal dimensions) the data
need only be set for the fi rst wheel. The selections
stay set until other new data are set or the machine
is switched off.
72