John Bean B800 Manuel D'utilisation page 112

8
A
8
8
8
112
5-74
5-75
5-76
5-76b
5-77
Operation
Figure 5-74 MINIMISATION "7", outside
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre
outer side exactly perpendicular to and above the
chuck.
— Confi rm by pressing key 8.
The MINIMISATION "8" screen appears (Fig. 5-76).
Figure 5-75 MINIMISATION "7", inside
If the wheel cannotbe turned over on the rim (e.g.:
Asymmetrical and Directional),
— press the menu key (A, Fig. 5-75), then
— continue as shown on screen
MINIMISATION "7" outside (Fig. 5-74).
If the wheel can be turned over on the rim;
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre, on
the inside of the wheel, exactly above the chuck.
— Turn the tyre over on the rim (tyre changer).
— Confi rm by pressing menu key 8.
The MINIMISATION "8" screen appears (Fig. 5-76b).
Figure 5-76b MINIMISATION "8"
— Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
— Confi rm by pressing menu key 8.
The MINIMISATION "9" screen appears (Fig. 5-77).