Table des Matières
Publicité
1
2
A
B
26
4
3
4-8
4-9
Layout
Fig. 4-8
SETTING
Settings Screen.
Opened using the SETTINGS key (7, Fig. 4-5).
Commands:
1 - HELP key - For selecting HELP texts.
2 - HOME key - Returns you to the starting screen
page (INTRO SCREEN).
3 - USER CAL key - Starts the USER CALIBRATION
F
procedure (
6.2).
4 - ESC key -
- Returns you to the MAIN MENU.
Note: Directly press the items in the list to select the
desired options. To change parameters, manually turn
the wheel shaft. When the required value is reached,
press it to enter it and complete the selection.
Fig. 4-9
COUNTERS
Counters Screen.
Open using the key for SETTINGS (7, Fig. 4-5) / Counters
(A, Fig. 4-9).
The screen pages for Counters and System Information
(B, Fig. 4-9), both accessible from the Settings Screen
Page, do not have parameter selection commands.
Instead, they respectively show Statistical Information
and information about the machine System.
Counters Screen Page list:
- Total Measuring Runs
- Measuring Runs with result OK
- Optimisation Cycles
- Assistance Service Runs
- Runs since last Calibration
- Wheel Clamping Cycles
........
Publicité
Table des Matières
