Wheel Profi Les Function - John Bean B 2000P Manuel D'utilisation

Table des Matières

Publicité

6-9
6-10
6-11
74
"MANUAL MODE"
6.1.4
Wheel Profi les function
(in MANUAL MODE only)
To balance more than one wheel of the same type
and with the same nominal dimensions, simply set
the data for the fi rst wheel only. The data set then
remains until other new data is set or the machine is
switched off.
Fig. 6-9 PROFILE
To make the wheel parameters available permanen-
tly use the WHEEL PROFILES function.
The wheel profi les function enables you to memo-
rize the values of certain wheel types that are often
balanced in the garage. Naturally this bypasses the
task of repeatedly setting wheel data. This function
is particularly useful for workshops that carry out se-
ries fi tting of tyre/rim assemblies or frequently handle
the same wheel types (e.g. workshops that offer rims
for retrofi tting).
The once–only storage of the rim data in the pro-
fi les guarantees that the same correction planes
are always used, in particular for alloy wheels, thus
providing consistent balance quality.
The function can be used to save the following data:
– Nominal wheel dimensions
– Values measured
– Position of weights (Modo Alu)
– Type of Vehicle
– Traceability positions (list from 1 to 9)
– Number of spokes (if loaded previously)
:
How to access
The WHEEL PROFILES menu can be accessed at
any time.
In the ENTERING WHEEL DATA menu (Fig. 6-10),
— Press the "SPECIAL" key (Fig. 6-11).
The WHEEL PROFILES screen is displayed (Fig. 6-9)
..
..........
_

Publicité

Table des Matières
loading

Table des Matières