Explanations - Becker Centronic TimeControl TC511 Notice De Montage Et D'utilisation

Assembly and Operating Instructions

Explanations

Selecting roller shutter
When the roller shutter function is used, the roller shutter remains locked after a
control button has been activated.
Selecting venetian blind
When the venetian blind function is being used, the venetian blind moves in
non¬maintained command mode in order to allow the slats to be positioned
more precisely. If you press and hold a control button for longer than 1 second,
the venetian blind will remain locked.
After the programmed intermediate position respectively lower final position has
been reached, the slats will be automatically adjusted (provided the reverse po-
sition has been programmed).
MAN/AUTO sliding switch
In the sliding switch setting, only manual command controls are carried out
(e.g.: UP, STOP, DOWN by pressing the relevant buttons).
In the sliding switch setting, automatic command controls are carried out
(e.g. shade function, twilight function, time, astro function,...)
Transmission control light
A radio signal is indicated by the transmission control light being lit.
If the battery starts running out, the transmission control light flashes during
transmission.
The transmitter power and/or radio range is reduced when the battery is run-
ning low. If the transmission control light is no longer lit when the pushbutton is
pressed, the batteries must be changed.
Group
Group control means controlling one or several receivers at the same time. The
programmed group is activated using a single command.
With the TC511, the group is driven via an RF channel.
Operating mode
You will see the time and the current operating mode e.g. HOLIDAY in the display.
OK button
When the OK button is pressed, the currently displayed values are saved.
38