Assembly and Operating Instructions
SETTING
INTERMEDIATE POSITION, VENTILATION/REVERSE, Prog1 END LIMIT
(Time/ position programming)
1. You have confirmed the HOLIDAY/LIGHT SENSOR menu levels. INTERMEDI-
ATE POSITION will appear.
2. You can set the switching time to move to the INTERMEDIATE POSITION using the
+/- button. The switching time is indicated in a few seconds or you can move
to the INTERMEDIATE POSITION from the upper end limit using the DOWN/
UP button.
3. Confirm by pressing OK.
4. You can set the switching time to move to VENTILATION/REVERSE using the
+/- button. The switching time is indicated in a few seconds or you can move
to the VENTILATION/REVERSE from the lower end limit using the UP/DOWN
button. Confirm by pressing OK.
5. You have confirmed the VENTILATION/REVERSE menu level. PROG1 END
LIMIT / PROG 1 INTERMEDIATE POSITION or PROG 1 VENTILATION/RE-
VERSE will appear.
6. You can select PROG 1END LIMIT, PROG 1INTERMEDIATE POSITION and
PROG 1VENTILATION/REVERSE using the +/- button.
7. Confirm your selection by pressing OK.
8. The function PROG1 END LIMIT has now been set.
9. Please read on for further programming options using the SETTING
menu.
54