Characteristics Of The Water To Be Used; Starting The Sterilization Cycle - Tecno-gaz Europa B evo Mode D'emploi

ENGLISH

8.4 Characteristics of the water to be used

TABLE SHOWING THE QUALITY LEVELS LAID BY THE UNI EN 13060: 2005
Evaporation residue
Silicon oxide
Iron
Cadmium
Lead
mg/l Remains of heavy metals apart
from iron, cardium, lead
Chloride (Cl')
Phosphate (P20s)
Conductivity (at 20° C)
Ph value (acidity level)
Appearance
Hardness (and alkaline earth ions)
8.5 Loading the material into the autoclave
Place the materials to be sterilized on the trays provided.
- never superpose the materials
- arrange the wrapped instruments, with the paper part facing upwards
- never bring the materials into contact with the sterilization chamber or the closing door
- put the scissors and dental forceps with the blade open
When you have place all the instruments close the door and you can read
CLOSED on the display.

8.6 Starting the sterilization cycle

Choose sterilization program most adaptable of load prepared and press the button
B-SELECT.
Each individual pressure changes program selection to the next.
After having chosen the program start the cycle by pressing the button B-START, the door
will lock automatically and the cycle will begin.
During the cycle, the display will show all parameters and relative information.
22
CEN STANDARD UNI EN 13060 : 2005
PICT.23
10
≤
1
≤
0.2
≤
0.005
≤
0.05
≤
0.1
≤
2
≤
0.5
≤
15
≤
5 ÷ ÷ ÷ ÷ 7,5
Transparent, clear, without
deposits
0.02
≤
mg/l
mg/l
mg/l
mg/l
mg/l
mg/l
mg/l
mg/l
µs/cm
mmol/l
DOOR