Using The Machine; Operating Principle; Description Of The Machine; Installation - Tecno-gaz Unika Mode D'emploi

Unika must be used only for the purpose of drying surgical instrumentarium which has been washed or rinsed in
water.
Do not insert flammable material or material that can be altered by heat, objects treated with flammable liquids, nor
objects or substances that can produce toxic emissions when exposed to heat.
Any improper use of the machine or negligence on the part of the operator may lead to injuries or damage the
environment and objects; in such cases TECNO-GAZ does not shoulder any responsibility.
To dry the instrumentarium, the machine generates a flow of hot air that flows on the objects and removes their
moisture as vapour.
Two tangential fans located in the top part of the machine convey the air onto electric resistances; they heat the air
which is blown onto the instrumentarium below.
The water remaining on the surface of the instrumentarium evaporates and is conveyed outside by the air flow.
The UNIKA dryer is an AISI 304 stainless steel compact case (see picture A, B) supported by four rubber feet.
The front includes control panel, with a luminous main scale switch and a mechanic-electrical timer to adjust
treatment time (see picture A pos. 1, 2).
The door to the drying chamber is located under the front control panel (see picture A pos. 4).
The air intakes for the motor-fans are on the sides of the machine.
The back includes the fuses and the mains lead (see picture B, pos. 5, 6); the moisture discharge grid is in the bottom
part.
The drying chamber contains a removable tray, upon which the objects to be dried are laid (see picture A pos. 3).
UNIKA must be placed on a stable flat surface, far from other equipment and not inserted in narrow spaces since the
machine produces heat and emits water vapour, albeit in small quantity.
It must be connected to an electric socket supplying 1.2 KW power and 220 V voltage and equipped with a safety cut-
out.
DUKF151_REV5.doc
PAR.4

USING THE MACHINE

PAR.5

OPERATING PRINCIPLE

PAR.6

DESCRIPTION OF THE MACHINE

PAR.7

INSTALLATION

14