RIDGID HD18000 Mode D'emploi page 14

OPERATION
Moving the Wet/Dry Vac
Should it become necessary to pick
the Vac up to move it, the Handles
on each side of the Dust Drum or the
Powerhead Carry Handle should be used
to lift.
To maneuver the Vac, the Cart Push
Handle in the rear of the Vac should be
used.
Dust Drum
Handles (2)
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
2. Align the Hose Release Button of the
Cart Push
Handle
Carry
Handle
3. (Optional) Attach the Extension Wand
4. Turn the Vac on and you are ready to
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
of injury to bystanders, keep them
clear of blowing debris.
!
blowing creates dust which might
be inhaled.
14
the Powerhead of your Wet/Dry Vac.
Tug-A-Long Positive Locking Hose with
Dual-Flex End with the Ridges on the
Blower Port. Push the Hose End straight
into the Blower Port until the Hose
Release Button fully engages the Blower
Port Ridges.
to swivel end of the Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
use your Vac as a Blower.
WARNING: Always wear safety
WARNING: To reduce the risk
CAUTION: Wear a dust mask if