Using The Hoist - Invacare Jasmine Manuel D'utilisation

Attaching the battery charger to a wall (applicable only to version with
separate battery charger)
1. Place the battery charger mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 165 mm from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 3 mm gap between the
screw head and the wall.
5. Put the battery charger mounting bracket onto the bottom mounting screw.
6. Drill the other two mounting holes.
7. Screw the mounting screws through the battery charger mounting bracket and into the wall.
Tighten securely.
8. Put the battery charger in place on the mounting bracket.
9. Plug the battery charger into an electrical outlet.
6.

Using the hoist

Lifting capacity: 200 kg (31,5 stone).
(patient+sling+spreader bar)
Using the hand control
1. Press "arrow up" on the hand control to raise the jib.
2. Press "arrow down" on the hand control to lower the jib.
3. Operation of the electric legs.
NB - Operating forces of buttons: Max. 5 N.
LED diodes on the control unit
The left green diode will light continuously when the control unit is connected to the mains.
The yellow right diode will light continously during charging, and go out when the battery is fully
charged. There is no indication when hand control buttons are pressed (exept from the remaining
battery capacity display or when the emergency lowering/raising system is activated).
12
HB8x Standard front covers (transp
HB8x Standard front covers (not t
1
2
3
* If a not transparant cover is wan