Charging The Battery; How To Charge The Batteries - Invacare Jasmine Manuel D'utilisation

Masquer les pouces Voir aussi pour Jasmine:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Brakes
1.
Stand behind the hoist and take a good hold of the handle bar.
2.
Press the pedals downwards with the foot on the back castors to activate the brake.
3.
Press the pedals upwards with the foot to release the brake.
Never try to activate/deactivate the brakes by hand - risk of squeezing !
Moving the hoist
1.
Stand behind the hoist and take a good hold of the handle bar.
2.
Release the brakes of the back castors.
3.
Now the hoist can be pushed or pulled to the desired location.
Note: To negotiate raised obstacles during movement of the unloaded hoist, it is recommended
to pull the hoist backwards.
This operation should only be performed when the hoist is in the unloaded condition.

Charging the battery

The hoists are equipped with an internal charger. It is recommended to charge the batteries
regularly to ensure optimal use of the hoist and prolong the life of the batteries. Furthermore, it is
recommended to charge the batteries before first use.
The control unit is equipped with a sound signal, which will beep when operating with low battery
capacity.
It is recommended to charge the batteries as soon as the sound signal is heard.
In addition, Jasmine
capacity, when pressing any hand control button.
When installing the battery onto the control unit, it takes a few seconds before the hoist is
operational.

How to charge the batteries:

1.
Connect the mains cable to the control unit and plug it in. It takes about 4 hours to charge
the batteries. Charging must take place in a room with good air ventilation. The charger stops
automatically when the batteries are fully charged.
2.
Remember to disconnect the charger cable before using the hoist again.
The emergency stop must not be activated - otherwise it will be impossible to
charge the batteries.
While charging takes place the hoist cannot be used.
Do not use or move the hoist without unplugging from the socket outlet.
Do not attempt to use the hoist if the battery housing is damaged. Replace a
damaged battery housing before further use.
is equipped with a display, indicating the approximate remaining battery
TM
Press down to activate
13
Push to release

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jasmine tm

Table des Matières