Increase And Decrease The Power Level; Auto-Stop; Locking The Extraction Tower; Cleaning Indications - Novy Panorama 120 Pro 4 Mode D'emploi

Run-out function: This function starts at the end of cooking.
For a fixed time, the remaining cooking vapours will be extracted
from the kitchen by the extraction tower at low extraction mode
and at a height of 10 cm. When recirculation is selected, the
recirculation filters are also dried.
The run-out time is set to 30 minutes by default in the recirculation
mode and 10 minutes in exhaust mode. It is recommended that
this function be allowed to carry out its function completely. At
the end of the run-out time, the motor and the extraction tower
will automatically switch off and the tower will close.

5.5 Increase and decrease the power level

The extraction tower can be set to 8 power levels, with 3 intense
levels (6, 7 and 8).
Activate the intense levels when cooking food with a strong
smell or vapour. On higher flow rates, the extraction tower
works for a fixed period of time: 1 hour on position 6, and 6
minutes on position 7 and 8 if the device is set to exhaust mode.
After this time, the extraction tower switches back to position 5.
Adjusting the power level:
Increase the power
Press [+]
Decrease the power
Press [–]

5.6 Auto-stop

In order to ensure the extraction does not keep running, the
motor switches off and the extraction tower closes automatically
after 3 hours (if the controller has not been changed during
these 3 hours).

5.7 Locking the extraction tower

In order to prevent the extractor hood from being inadvertently
switched on, e.g. when cleaning the glass, the controls are locked.
Locking the extraction tower
Locking
Hold finger on for 3 seconds of the
extraction tower.
Unlocking
Hold finger on for 3 seconds of the
extraction tower.

6 Cleaning indications

6.1 Cleaning indication for grease filter


Indication: LED next to
After 20 cooking hours, the LED next to the
light up.

Follow the cleaning instructions as described in
the chapter, Cleaning.
After having cleaned and replaced the grease filters, reset the
cleaning indication.
Reset: press the
extraction tower is completly downwards.
6.2 Replacement indicator recirculation filter
(only with recirculation)

Indication: LED next to
Display
Brighter AAfter a fixed time, the LED on the hood touch will light up. This
LED(s) indicates that the recirculation filter needs to be replaced.
LED(s) 
Follow the cleaning instructions described in the
dim
recirculation box / filter manual.
A new recirculation filter can be obtained from a specialist dealer
or from the Novy website. After replacing the recirculation filter,
reset the cleaning indication.
Reset: press the
extraction tower is completly downwards.

6.3 I/O module connection

The device can be optional equipped with the Input/Output
module n° 990036 (as of version v5).
When the input of the module is used in "closed" input situation
the extraction tower will move to the desired height only the
extraction will not start.
Display
The 2 leds between the cleaning indication
LED
blink.
lights up
The extraction only starts when the input situation is "open".
LED
The input can be used for example in combination with a
off
sinwow switch in duct out mode.
When the output of the module is used the relay will close when
the extraction is active.
The output remains closed also 5 minutes after closing the
extraction tower.
– 59 –
lights
control key for 3 seconds when the
lights
control key for 3 seconds when the
and
symbol will
will