Control Panel Locking; Operation Of The Ventilation Tower; Switch On And Off And Run-Out Function; Increase And Decrease The Power Level - Novy 1811 ONE Mode D'emploi

4.2.12 Control panel locking

To avoid modification of the setting of the cooking
zones , in particular during cleaning, the control panel
can be locked (with exception to the On/Off key [ 0/I ]).
Action Control panel
Locking the
Press [
hob
Unlock the
Press [
hob

4.3 Operation of the ventilation tower

4.3.1 Switch on and off and run-out function

ATTENTION: when switching on the extraction, the
tower in the centre of the induction cooking plate au-
tomatically moves up. Make sure no objects are on the
tower.
Action Control panel
Switch on
press [
two seconds
Run-out
press [
function
Switch off
press [
Switch off with 30 minute delay: Switch the hood off
30 minutes after cooking is finished. The delay function
is set to 30 minutes. Use the delay function to get the
best results out of the monoblock filter.

4.3.2 Increase and decrease the power level

Action Control panel
Switch on
press [
two seconds
Increase the press [ + ]
power
Decrease press [ - ]
the power

4.3.3 Low position of extraction

With the [symbol] key you can select a fixed set power
with which the tower will remain at a low level. This
function could be used for cooking an egg, for exam-
ple.
Display
locking light
] during 6s
on
locking light
] during 6s
off
Display
the white
] and hold for
LED lights
up
the white
]
LED flashes
no indica-
]
tion
Display
the white
] and hold for
LED lights
up
The white
LEDs
will light
up more
intensely (a
total of four
LEDs)
The white
LEDs will
light up less
intensely
until they
are off

4.3.4 Auto-stop

To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).

4.3.5 Concentration of the ventilation

When cooking only on one side of the cooking plate,
you can concentrate the extraction of fumes on this
side. Using the switch you can concentrate the extrac-
tion of fumes on the left or on the right side. This even
further increases the efficiency of the unit.

4.4 Cleaning indications

4.4.1 Grease filter

Indication: white led next the symbol
starts burning
After 20 cooking hours, white led next to the symbol
starts burning.
Follow the cleaning instructions as described in
the chapter Cleaning.
After having cleaned and placed back the fat filters, re-
set the cleaning indication.
Reset: press the key for three seconds

4.4.2 Recirculation (option)

Indication: white led next the symbol
starts burning
The white indicator lamp will burn after 200 working
hours (time to regenerate the monoblock filter).
Follow the cleaning instructions as described in
the chapter Cleaning.
After the regeneration and after having placed back the
Monoblock filter, start up the cleaning indication again.
Reset: press the key for three seconds.
If the programming is not carried out, the programming
is automatically set after the chimney hood has been
switched on 10 times.

5 COOKING ADVICES

Pan quality
Adapted materials: steel, enamelled steel, cast iron,
ferromagnetic stainless-steel, aluminium with ferro-
magnetic bottom.
Not adapted materials: aluminium and stainless-steel
without ferromagnetic bottom, cupper, brass, glass,
ceramic, porcelain.
The manufacturers specify if their products are com-
patible induction. To check if pans are compatibles:
• Put a little water in a pan placed on an induction
heating zone set at level [ 9 ].This water must heat in
a few seconds.
• A magnet stucks on the bottom of the pan.
EN 41