Akai Professional TIMBRE WOLF Guide D'utilisation page 5

11. Voice Mode Selector: Use this switch to set Timbre Wolf's voice mode (Mono, Poly, or
Unison), which determines which voice/voices you will hear. See
Poly, or Unison
12. Voice Controls: Use these controls to adjust the sounds of their respective voices.
•
Volume: Turn this to set the voice's volume.
•
Tune: Turn this to tune the pitch of the voice.
•
Filter Cutoff: Turn this to set the cutoff frequency of the voice's low-pass filter.
•
Filter Res: Turn this to set the resonance of the voice's low-pass filter. This
determines the slope of filter at the cutoff frequency.
•
Env Amt: Turn this to set how much the voice is affected by the filter envelope. (The
envelope's effect will still be heard even at the minimum setting.)
•
Decay: Turn this to set how long it takes for the voice's amplitude envelope to
continue after the note stops playing.
13. Mute/Select: Press and hold Shift and then press this button to mute or unmute the
corresponding voice. The light next to the button is lit if the voice is unmuted, unlit if the
voice is muted. This affects sequencer playback only; you can still use play the voice using
the keyboard or an external MIDI device.
14. Play/Stop: Press this button to start or stop playback. During playback, press and hold
Rec and then press this button to restart playback from the very beginning of the pattern.
Press and hold Shift and then press this button to send a MIDI Panic (All Notes Off)
message.
When Sync is set to Gate, press this button to return to Step 1. See
to learn more.
15. Rec: Press this button to record-arm the sequencer. See the
guide to learn more. During playback, press and hold this button and then press Play/Stop
to restart playback from the very beginning of the pattern.
16. Velocity: Press this button to edit the velocity of a step. See the
guide to learn more.
17. Seq Variation: Press this button to select whether you are playing/editing Sequence A,
Sequence B, or Sequence A and B. See the
18. Fill: Press this button to play the fill for the current sequence (A, B, or A and B). See the
About Patterns
19. Pattern Select: Press this button and then select a pattern by (A) pressing one of the 16
Step Switches to select the pattern of the same number or (B) turning the Tempo knob
(when selecting a pattern, the Tempo knob will not adjust the tempo). Press Pattern
Select again to return to normal operation. If you do this during playback, the current
pattern will finish before moving to the next one.
Press and hold Shift and then press this button to set the pattern's length. The pattern's
length (in steps) will appear in the display, and the same number Step Indicators will light
up amber. Press one of the 16 Step Switches or turn the Tempo knob to set the pattern's
length (in steps). If the Seq Variation button has either A or B lit, the maximum pattern
length is 16 steps. If both A and B are lit, the maximum pattern length is 32 steps, and the
minimum pattern length is 17 steps. Press Pattern Select (without holding Shift) to return
to normal operation.
20. Main Volume: Turn this knob to set the output volume of Timbre Wolf's Main Out and
Phones Out.
21. Howl: Turn this knob to set the amount of overdrive (distortion) applied to Timbre Wolf's
Main Out and Phones Out. This does not affect the sound of Voice Outs 1–4.
to learn more.
section to learn more.
About Patterns section to learn more.
Voice Settings > Mono,
Transport Controls
Sequencer section of this
Sequencer section of this
5