Akai Professional TIMBRE WOLF Guide D'utilisation page 13

Saving, Copying, and Clearing
Saving
To save patterns, sequences/fills, or global settings:
1. Press and hold Shift, and then press Step Switch 16 (Save). (To cancel and exit the process at
any time, release Shift.)
2. While still holding Shift, turn the Tempo knob to select what you want to save: all patterns and
global settings (All), the current pattern only (One), or the global settings only (Glo).
Important: Global settings include the tempo and Sync settings.
3. Press Step Switch 16 (Save), and then release Shift.
Copying
Important: Copying does not save a pattern, sequence, or fill. You must save it, as well.
To copy the current pattern:
1. Press and hold Shift, and then press Step Switch 14 (Copy). Keep holding Shift. The Step
Indicators for non-empty patterns will flash amber. The Step Indicators for empty patterns will
be unlit. (To cancel and exit the process at any time, release Shift.)
2. Turn the Tempo knob to select Pat in the display.
3. Press the Step Switch with the same number as your desired "destination" pattern (the pattern
you want to copy to). The pattern will copy and load the destination pattern. After that, release
Shift.
To copy the current sequence or fill:
Important: You can copy a sequence or fill only to another sequence or fill in the same pattern.
1. Press and hold Shift, and then press Step Switch 14 (Copy). Keep holding Shift. The Step
Indicators for non-empty patterns will flash amber. The Step Indicators for empty patterns will
be unlit. (To cancel and exit the process at any time, release Shift.)
2. Turn the Tempo knob to select where you want to copy the sequence or fill (within the same
pattern):
•
S-A: The sequence or fill will be copied over Sequence A.
•
S-b: The sequence or fill will be copied over Sequence B.
•
F-A: The sequence or fill will be copied over Fill A.
•
F-b: The sequence or fill will be copied over Fill B.
3. Press Step Switch 14 (Copy), and then release Shift.
Clearing
Important: Clearing does not save the empty pattern, sequence, or fill. You must save it, as well.
To clear the current pattern, sequence, or fill:
1. Press and hold Shift, and then press Step Switch 15 (Clear). Keep holding Shift. (To cancel and
exit the process at any time, release Shift.)
2. Turn the Tempo knob to select which part of the current pattern you want to clear.
•
Pat: Both sequences and fills will be cleared.
•
S-A: Only Sequence A will be cleared.
•
S-b: Only Sequence B will be cleared.
•
F-A: Only Fill A will be cleared.
•
F-b: Only Fill B will be cleared.
3. Press Step Switch 15 (Clear) again, and then release both buttons.
13