What To Do If The Descaling Process Is Interrupted - Gaggia MAGENTA PLUS Mode D'emploi

English
30
4219-465-02821 MAN. GAG. MAGENTA Plus 120V EN-FR Rev 01.indd 30
5 Pour the entire bottle of Gaggia descaling solution into the water tank and fill
the tank with water up to the CALC CLEAN level. Reinsert it into the machine.
6 Place a large recipient (1.5l) under the steam tube and the coffee dispensing
spout.
7 Follow the instructions shown on the display to launch the descaling
procedure. This procedure lasts approximately 25 minutes and consists of
a descaling cycle and a rinse cycle, carried out with dispensing at regular
intervals.
8 Once the descaling cycle is complete, rinse the water circuit and tank by
following the instructions shown on the display.
9 Position the INTENZA+ filter back into the water tank.
Note: it is possible to pause and resume the procedure at any time by pressing the
START/STOP button.
START/STOP
Warning: when the descaling procedure is active, the brew group cannot be
removed. Wait for the descaling process to end, then remove the brew group.

What to do if the descaling process is interrupted

You can exit the descaling procedure by keeping the ON/OFF
control panel, pressed for a few seconds. If the descaling procedure is interrupted
before its completion, proceed as follows:
1 Empty the water tank and wash it thoroughly.
2 Fill the water tank with running water up to the CALC CLEAN level mark, then
switch the machine back on. The machine will warm up and perform an
automatic rinse cycle.
3 Before preparing any beverages, carry out a manual rinse cycle as described in
the dedicated chapter.
Note: if the procedure has not been completed, it will be necessary to carry out
another descaling procedure as soon as possible.
button on the
ON/OFF
21/01/2021 11:45:22