Dispensing Hot Water - Gaggia MAGENTA PLUS Mode D'emploi

STEAM
ESPRESSO LUNGO
AMERICANO
ACQUA CALDA
4219-465-02821 MAN. GAG. MAGENTA Plus 120V EN-FR Rev 01.indd 21
4 HOME button to open the beverage menu. Select " STEAM " and
Press the
press the START/STOP
HOME
5 To froth the milk correctly, the steam nozzle must always be in contact with the
milk and not with the froth.
Therefore, as the layer of froth increases, the jug must be slightly raised trying
to keep the nozzle in contact with the milk, without touching the bottom of the
jug.
Once the desired frothing has been achieved, the steam nozzle must be
pushed further to heat the milk well.
6 When the milk froth comes to the desired consistency. Press the START/STOP
button to stop steam dispensing. Wait until dispensing stops completely
before removing the jug.
START/STOP
Note: It is advisable to always keep a hand on the rounded part of the jug to feel
the temperature increase of the milk.
Note: After frothing the milk, to make the froth more compact, it is advisable to
lightly tap the jug on a flat surface and leave it to rest for at least 30 seconds. The
milk will become more homogeneous.
Note: After frothing milk, clean the circuit by dispensing a small quantity of hot
water. Be careful as hot water or steam sprays might be present.

Dispensing hot water

Warning: when the machine starts preparing hot water, the classic pannarello or
steam wand (depending on the model) spout may spray steam and hot water.
1 Place a container under the classic pannarello or steam wand (depending on
the model).
2 Press the HOME button and using the "
pages.
HOME
3 Press the "HOT WATER" button. Finally, press the START/STOP
commence dispensing.
Note: you can interrupt dispensing at any time by pressing the START/STOP
button.
If you wish to customise the settings of a specific beverage, please refer to the
"Beverage Customisation" chapter.
button to start frothing
START/STOP
" button browse the various
English
21
button to
START/STOP
START/STOP
21/01/2021 11:44:59