Lubricating The Brew Group - Gaggia MAGENTA PLUS Mode D'emploi

English
28
CLEAN
BREW GROUP
DESCALING
4219-465-02821 MAN. GAG. MAGENTA Plus 120V EN-FR Rev 01.indd 28
Cleaning the brew group with cleaning tablets for the
removal of oily coffee residues
Warning: use only Gaggia cleaning tablets to remove oily coffee residues.
1 Place a container under the coffee dispensing spout.
2 Press the CLEAN/SET
the display.
3 Select "BREW GROUP CLEANING" and press the "
START/STOP to start the cleaning procedure.
START/STOP
4 Follow the instructions shown on the display to clean the brew group correctly.
5 The procedure will take approximately 5 minutes. START/STOP
used to pause and resume the procedure.

Lubricating the brew group

In order to ensure the perfect performance of the machine, it is necessary
to lubricate the brew group. Refer to the following table for the frequency of
lubrication.
Frequency of use
Low
Regular
High
1 Turn off the appliance and disconnect the power cord.
2 Remove the brew group and rinse it using lukewarm water - see the "Cleaning
the brew group under running water" chapter.
3 Apply a thin layer of the lubricant provided around the insertion pin on the
lower part of the brew group.
button and select the " CLEAN " button shown on
clean/setting
Number of beverages prepared
daily
1-5
6-10
>10
" button, then press
can be
START/STOP
Lubrication
frequency
Every 4 months
Every 2 months
Every month
21/01/2021 11:45:17