Technical Data - ZANKER KBU14001DK Notice D'utilisation

Problem
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the max-
imum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make
sure that the light comes
on.

Technical data

Dimension
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
16
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Height
Width
Depth
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
815 mm
596 mm
550 mm
230-240 V
50 Hz
Solution