Technical Data; Installation - ZANKER KBA14411SB Notice D'utilisation

Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance should be installed in a dry, well ventila-
ted indoor where the ambient temperature corresponds
to the climate class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for some types of
models when operating outside of that range. The cor-
18
3.
Height
Width
Depth
rect operation can only be guaranteed within the speci-
fied temperature range. If you have any doubts regard-
ing where to install the appliance, please turn to the
vendor, to our customer service or to the nearest Serv-
ice Centre
Electrical connection
Before plugging in, ensure that the voltage and frequen-
cy shown on the rating plate correspond to your domes-
tic power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect
the appliance to a separate earth in compliance with
current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
If necessary, replace the defective door gaskets.
Contact the Service Center.
873 mm
540 mm
549 mm
12 h
230 V
50 Hz