Replacing The Lamp; Closing The Door; Technical Data; Installation - ZANKER ZKK8023 Notice D'utilisation

Problem
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same

Technical data

Dimension of the recess
The technical information are situated in the rating plate
on the internal left side of the appliance and in the en-
ergy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Possible cause
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high. Let the product temperature decrease
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Height
Width
Depth
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
power (the maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Force Center.
1225 mm
560 mm
550 mm
Solution
17