Replacing The Lamp; Closing The Door - ZANKER KBU12401DK Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The temperature in the refrig-
erator is too high.
The temperature in the freez-
er is too high.
There is too much frost.

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the
maximum power is
shown on the lamp cov-
er).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make
sure that the light comes
on.
20
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Products are too near to each other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set
correctly.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Store products so that there is cold air
circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.

Closing the door

1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installa-
tion".
3.
If necessary, replace the defective door gaskets.
Contact the Service Center.
Solution

Publicité

Table des Matières
loading

Table des Matières