Operation; First Use; Daily Use; Helpful Hints And Tips - ZANKER ZKK8023 Notice D'utilisation

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
Switching off
To turn off the appliance, turn the Temperature regu-
lator to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower set-
tings to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.

First use

Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.

Daily use

Movable shelves
The walls of the refriger-
ator are equipped with a
series of runners so that
the shelves can be posi-
tioned as desired.
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be placed at different heights.

Helpful hints and tips

Hints for energy saving
• Do not open the door frequently or leave it open
longer than absolutely necessary.
14
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping
in mind that the temperature inside the appliance de-
pends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
Important! Do not use detergents or abrasive pow-
ders, as these will damage the finish.
To make these adjustments proceed as follows:
gradually pull the shelf in the direction of the arrows
until it comes free, then reposition as required.
• If the ambient temperature is high and the Temper-
ature Regulator is set to low temperature and the
appliance is fully loaded, the compressor may run