Troubleshooting Guide - Dru SAXO Instructions D'installation Et Mode D'emploi

OBSERVED PROBLEM:
A. No Transmission:
(motor does not turn)
WARNING:
Do not create an electrical short between the
batteries/battery box and metal parts of the
appliance. It will damage the remote
(see figure 2).
B. No Ignition:
WARNING:
Do not create an electrical short between the
batteries/battery box and metal parts of the
appliance. It will damage the remote
(see figure 2).
fig. 2
C. No Tone:
POSSIBLE CAUSE:
1. Receiver must learn new code.
2. Dead batteries.
3. Receiver damaged.
4.Transmitter damaged.
5. Motor cable at valve broken.
6. Bent pins on 8 wire connector.
7. If the receiver is surrounded by metal,
it can reduce the transmission range.
1. ON/OFF switch in OFF position. Manual
override knob in MAN position.
WARNING:
Make sure that the antenna is not too close to
the ignition cable and ignition coil (beneath the
cover). It will damage the receiver (see figure 3).
correct position
2.
1.
of antenna
1. antenna ignition cable
2. coil (inside)
3. antenna
fig. 3
1. Receiver damaged.
31

TROUBLESHOOTING GUIDE

REMEDY:
1. Press and hold the receiver's reset button
until you hear 2 acoustic signals.After the
second longer acoustic signal release the
reset button and within the subsequent 20
seconds, press the
until you hear an additional long acoustic
signal confirming the new code is set
(see figure 1).
2. Replace the batteries.
3. Replace receiver and reprogram code
(remedy 1).
4. Replace the transmitter and reprogram the
code (remedy 1).
5. Replace motor cable at valve.
6. Straighten pins on 8 wire connector.
7. Change the position of the antenna.
fig. 1. Receiver with Reset button
1.Turn ON/OFF switch to ON position and
the knob for the manual override to the
ON position (see figure 4).
3.
fig. 4
1. Replace receiver and reprogram code
( remedy 1).
on the remote handset,
Saxo