Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
to the set temperature.The flame height is then
automatically adjusted to achieve the Daytime set
temperature.
TEMP MODE - Nighttime Setback
Temperature Mode:The room temperature is measured
and compared to the Nighttime Setback temperature.The
flame height is then automatically adjusted to achieve the
Nighttime Setback temperature.
TIMER MODE - The Timer setting allows you to
set two (2) burner ON times and two (2) burner OFF
times every 24 hours.
NOTE: The display shows the set temperature every
30 seconds.
Changing the Mode of Operation
Briefly pressing the SET button changes the mode of
operation in the following order:
➛
➛
➛
and back to
NOTE: MAN mode can also be reached by pressing either
the
or the
.
Setting the Temperature
1. Select either the
MODE or the
briefly pressing the SET button.
2. Hold the SET button until the TEMP display flashes.
3. Set the desired temperature with
NOTE: 4.5°C/40°F is the min. temperature setting.
4. Press OFF button or simply wait and the display will go
to the temperature control mode.
NOTE: If you would like the Nighttime Setback
temperature control to turn off, decrease the
nighttime temperature until [---] appears on the
display.
Setting the Timer
1. Select Timer mode by briefly pressing the SET button.
2. Press and hold the SET button until "TIMER" is displayed
on the lower right hand side.
3. Press and hold the SET button until the P1
the time display flashes. Set the hour by pressing the
and set the minutes by pressing the
4. Briefly press SET button for the next burner cycle time.
Example: P1 continue through P2
If Nighttime Setback Temperature is turned off,
P2
will not appear.
5. Once all four (4) times are set, press OFF or simply
wait to complete programming.
N.B.: timer and thermostat functions will only work if
the appliance is on stand-by with the pilot alight.
Manual ignition
It is also possible to ignite the heater manually if necessary.
To do this, remove the glass pane.Turn button A (fig 24) to
MAN. Now, poking a pen or screwdriver etc. through the
hole in button A, press the coil.The pilot-light burner will
now fill with gas and can be ignited with matches or a
lighter. After 10 seconds you can release the coil and the
pilot light will stay alight. Replace the glass window frame
and turn button A back to ON. Now you can regulate the
heater by remote control or manually by turning button B.
The ticking heard when the button is turned is perfectly
normal.
Changing the code
The remote control code can be
changed if so required.This will require
changing the DIP SWITCH, which is on
the remote control near the battery.
Once the code has been changed, press
.
the reset button on the receiver until
you hear two signals. After the second,
longer signal release the reset button and within 20
seconds press
extra long signal.This means that the new code has been
MODE by
confirmed.
or
.
and
.
and P2 .
28
on the remote control until you hear an
Publicité
Chapitres
Dépannage
