Battery Precautions; Remote Control Unit; Battery Installation - Teac SR-2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26

Battery Precautions

< Be sure to insert the batteries with correct positive "+"
and negative "_" polarities.
< Use batteries of the same type. Never use different
types of batteries together.
< Either rechargeable and non-rechargeable batteries can
be used. Refer to the precautions on their labels.
< When the unit or the remote control unit is not to be
used for a long time (more than a month), remove the
battery from the remote control unit to prevent them
from leaking.
< If the batteries leak, wipe away the leakage inside the
battery compartment and replace the batteries with
new ones.
< Do not use any batteries other than those specified. Do
not mix new batteries with old ones or use different
types of batteries together.
< Do not heat or disassemble batteries and never throw
them in fire or water.
< Do not carry or store batteries with other metallic
objects. Doing so could cause batteries to short circuit,
leak or explode.
< Never recharge a battery unless it is a verified
rechargeable type.

Remote Control Unit

The provided remote control unit allows the unit to be
operated from a distance.
When operating the remote control unit, point it towards
the remote sensor on the front panel of the unit.
< Even if the remote control unit is operated within the
effective range (5 m), remote control operation may be
impossible if there are any obstacles between the unit
and the remote control unit.
< If the remote control unit is operated near other
products which generate infrared rays, or if other
remote control devices using infrared rays are used
near the unit, it may operate incorrectly. Conversely, the
other products may operate incorrectly.

Battery installation

1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3 V).
3. Close the cover.
Battery replacement
If the distance required between the remote control
unit and main unit decreases, the battery is exhausted.
In this case replace the battery with a new one.
5

Publicité

Table des Matières
loading

Table des Matières