Listening To An External Source; Setting The Timer - Teac SR-2 Mode D'emploi

Listening to an External Source

1 Connect the PHONES jack (audio output jack) of a
portable audio player to the AUX IN jack of the
SR-2 using the supplied stereo mini plug cable.
You can use this way of connection to listen to an
iPod that has no Dock connector or that has, but an
appropriate Dock adapter is not available.
2 Select "AUX" using the FUNCTION button.
3 Play the source, and adjust the volume of both
the SR-2 and the audio player.
When using the headphones jack of your mini player,
you must adjust the volume of the mini player or you
may hear no sound from your SR-2.
< Turning the volume of the mini player up too high may
cause the sound from your SR-2 to be distorted. In this
case, reduce the volume of the mini player until the
distortion stops and then adjust the volume level of the
SR-2 to a comfortable listening level.
22
Timer (1)
< SR-2 can be set two different timer setting separately.
< Adjust the clock before setting the timer (see page 12).

Setting the timer

Following is the case to set the ALARM 1.
To set the ALARM 2 follow similar steps.
1 Press and hold the ALARM 1 button for more than
2 seconds to display "ON".
The clock and the Timer indicator ( ) blinks on the
display.
< If no button is pressed for about 8 seconds, the timer
setting mode will be cancelled.
2 Turn the TUNING knob to set the hour, and then
press the ALARM 1 button.
TUNING
ALARM 1, ALARM 2