Troubleshooting - Teac SR-2 Mode D'emploi

If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling your dealer or TEAC service center.
General
No power.
e Check the connection to the AC power supply. Check
and make sure the AC source is not a switched outlet
and that, if it is, the switch is turned on. Make sure
there is power to the AC outlet by plugging another
item such as a lamp or fan into the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES jack.
e If "MUTING" is blinking on the display, press the
MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control unit does not work.
e If the battery is exhausted, replace it with a new one
(see page 5).
e Use remote control unit within the range (5 m) and
point at the remote sensor on the front panel.
e Clear obstacles between the remote control unit and
the main unit.
e If a strong light is near the unit, turn it off.
iPod/iPhone Player
Cannot insert the iPod/iPhone.
e Check the Dock adapter (see page 11).
e Remove dust or obstacles from the Dock connector
of the SR-2 and the iPod/iPhone, and insert the iPod/
iPhone again.
Will not play.
e Remove the iPod/iPhone from the Dock, wait a few
seconds, and insert it again.
e Software update may solve the problem. Visit the
Apple website and download the latest iPod/iPhone
Software (see page 11).
Cannot operate the iPod/iPhone.
e Set off the HOLD switch of the iPod/iPhone.

Troubleshooting

Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Rotate the FM or the AM antenna until you get stations
clearly.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it again.
Using the alarm on your iPod touch/iPhone
If you specify [Slide to power off] on your iPod touch/
iPhone, you cannot use the alarm even if the iPod
touch/iPhone is docked to SR-2.
To use the alarm on your iPod touch/iPhone, do not
select [Slide to power off]. (The screen can be turned
off without any problem.)
If Video is displayed on your iPod touch/iPhone's screen,
you cannot use the alarm even if the iPod touch/iPhone
is docked to SR-2.
To use the alarm on your iPod touch/iPhone, select any
item other than Video.
25