Installation And Commissioning; Assembly - Wessamat Micro Cube M 120 Mode D'emploi

Operating instructions

5. Installation and commissioning

Follow the instructions below during assembly and installation to ensure optimum functioning of the ice cube
maker:

5.1 Assembly

•
The ice cube maker must not be operated in the following environments:
•
atmosphere subject to explosion hazard,
•
toxic atmosphere,
damp rooms.
Direct heat sources such as ovens, dishwashers etc. will impair the performance of the ice cube maker and
increase the cleaning effort and energy consumption.
CAUTION: Under certain ambient conditions (e. g. high ambient temperature and/or high humidity) there can
be formation of condensation water in the area of the ice cube maker.
5.1.1 Unpack the machine after delivery. (Please keep the packaging in case you have to return the machine
for servicing.) Prior to installation, please remove the white protective foil from the covering panels.
5.1.2 The device should be positioned absolutely level. For models with storage bin please use the adjustable
feet for positioning (see Fig. 5.1.2). Then create a slight slope towards the back by setting a height difference of
no more than 5 mm between the front and rear feet. Do not alter the horizontal alignment across the width
of the device!
+
-
Fig. 5.1.2: Adjustable feet
NOTE: All connections must comply with the relevant regulations! Please note the technical data and operating
conditions chapter 4.4 - 4.7.
BA-MicroCube-1213-0
English
9