Bosch EPS 118 Notice Originale page 52

en 52 | EPS 118 | Important notes
2.4 Obligation of workshop operator
No smoking is permitted in the immediate vicinity of
the product. Appropriate signs must be posted by the
workshop operator.
The workshop operator is obliged to ensure that all
measures geared towards the prevention of accidents,
industrial diseases, labor-related health risks are taken
and measures towards making the workplace fit for
people to work in are carried out.
The workshop operator is bound to ensure that all
hydraulic equipment and operating material is set up,
modified and maintained by skilled personnel only or
under the guidance and supervision of skilled person-
nel in accordance with hydraulic principles.
The workshop operator must ensure that only autho-
rized and skilled personnel operate the product. The
workshop operator must define EPS manager-respon-
sibility, including in terms of traffic law regulations,
and enable the EPS manager to reject any instructions
issued by third parties which may impair safety.
Specifications for electrical systems (DGUV regulation
3)
Electrical engineering in Germany is subject to the ac-
cident prevention regulations of the trade association
"Electrical Plant and Equipment as under DGUV regu-
lation 3 (previously BGV A3)". In all other countries
the applicable national regulations or acts or decrees
are to be adhered to.
Basic rules
The workshop operator is bound to ensure that all
electrical equipment and operating material is set up,
modified and maintained by skilled electricians only
or under the guidance and supervision of a skilled
electrician in accordance with electrical engineering
principles.
Furthermore, the workshop operator must ensure that
all electrical equipment and operating material is ope-
rated in keeping with electrical engineering principles.
If a piece of electrical equipment or operating ma-
terial is found to be defective, i.e. it does not or no
longer complies with electrical engineering principles,
the workshop operator must ensure that the fault is
rectified immediately and, in the event that imminent
danger exists, also ensure that the electrical equipment
or the electrical operating material is not used.
|
1 689 989 300 2020-03-24
Tests (taking Germany as an example):
R
The workshop operator must ensure that all electri-
cal equipment and operating material is tested to
see if it is in proper working order:
$
Before starting up for the first time and, fol-
lowing any modification or repair work, before
a restart by a skilled electrician or under the
guidance and supervision of a skilled electrician.
$
At specific time intervals. Intervals are to be
measured such that faults that must be expec-
ted to occur, are determined in good time.
R
The test is to take the electrical engineering prin-
ciples relating hereto into account.
R
Upon request of the trade association a test manu-
al is to be maintained into which specific entries
are made.
Robert Bosch GmbH