EUROM POLAR 7000AC Livret D'instructions page 21

After pressing a button it can take several seconds to a minute before the device reacts.
This is normal and occurs because the device must first run through internal processes
After switching off you must wait for 4 minutes before you may (and can) switch the device
Automatic operation
 Switch the air conditioner on with the ON/OFF button – the display shows the modes.
 Set the MODE button to 'AUTO'
 Set the desired ventilator speed with the SPEED button
The air conditioner now starts to work. Pressing the ON/OFF button again switches the air
conditioner off again.
Cooling
 Switch the airco on with the ON/OFF button – the display shows the modes.
 Set the MODE button to 'COOL'.
 Use the ▼&▲buttons to set the desired temperature (between 16°C and 32°C.).
 Use the SPEED button to set the desired ventilator speed.
The air conditioner now starts to operate. Pressing the ON/OFF button again switches the air
conditioner off again.
Ventilation
 Switch the airco on with the ON/OFF button – the display shows the modes.
 Set the MODE button the 'FAN' mode.
 Set the desired ventilator speed with the SPEED button.
The airco starts to operate. Pressing the ON/OFF button again switches the air conditioner off
again.
Dehumidification
 Ensure that the water drain hose is correctly attached, see page 18.
 Switch the airco on with the ON/OFF button – the display shows the modes.
 Set the MODE button to the 'DRY' mode.
 Use the ▼&▲buttons to set the desired temperature (between 16°C and 32°C.).
 Use the SPEED button to set the desired ventilator speed.
The air conditioner now starts to operate. Pressing the ON/OFF button again switches the air
conditioner off again.
ATTENTION!
 After switching off, wait until the slats of the air outlet are closed before you remove the plug
from the socket.
 During operation, always point the remote control at the airco receiver.
 The distance between the remote control and device may be a maximum of 8 metres.
 Ensure that the connection between the remote control and the device is not blocked by
obstacles.
 Handle the remote control with care – do not drop or throw it.
21
before it executes the mode.
on again.