EUROM POLAR 7000AC Livret D'instructions page 17

CONTROL PANEL
COOL - cooling indicator light
DRY - dehumidify indicator light
FAN - ventilator indicator light
1 - on/off button
2 - buttons to set the temperature higher/lower
- mode selector button (MODE). Every time you press it the mode changes from
cooling to dehumidification to automatic.
3 - temperature indicator screen
Attention:
 The abovementioned modes 1, 2 & 3 work in the manner described under 'Remote control'.
 The other modes and also the speed of the ventilator can only be adjusted with the remote
control, not on the control panel.
INSTALLATION
The EUROM POLAR 7000 & 9000 are mobile air conditioning/ dehumidifying units that can be
moved from room to room. Install as follows:

Remove all packaging material and ensure that the unit remains in an upright position.

Before use, check that all accessories are present and that there is no damage to the
accessories or the unit itself. Do not use a damaged unit; take it back to your supplier!

Place the unit on a sturdy, flat, dry and horizontal base near an electrical socket and a
discharge point for hot air, e.g. a window that can be opened slightly. Make sure that the unit
has at least 50 cm of free space on all sides and take all safety instructions into account.
Fastening the window beam
The window beam supplied fits into most standard
windows that can be opened horizontally or vertically.
It may be necessary to alter special windows. The
beam fits into openings of a minimum of 67.5 cm and
a maximum of 125 cm. Fasten the correct dimension
with a screw and nut. Refer to the illustration for
installation.
17