Publicité
Les langues disponibles
Les langues disponibles
Free WArnInG lABel rePlACeMent: If your warning labels
become illegible or are missing, call 1-800-4-D
replacement.
WARNING
DRAIN TANK DAILY
OR AFTER EVERY 4 HOURS OF USE. CONDENSATION BUILD-UP MAY CAUSE
CORROSION INSIDE TANK RESULTING IN TANK FAILURE. SEE MANUAL FOR INSPECTION PROCEDURES.
TO DRAIN TANK OPEN VALVE SLOWLY AND TILT COMPRESSOR TO EMPTY ACCUMULATED WATER.
DRENE EL TANQUE A DIARIO O DESPUÉS DE CADA 4 HORAS DE USO. LA ACUMULACIÓN DE
ADVERTENCIA
CONDENSACIÓN PUEDE OCASIONAR CORROSIÓN DENTRO DEL TANQUE Y PROVOCAR FALLA DEL
TANQUE. CONSULTE EL MANUAL PARA CONOCER LOS PROCEDIMIENTOS DE INSPECCIÓN. PARA DRENAR EL TANQUE, ABRA LA
VÁLVULA LENTAMENTE E INCLINE EL COMPRESOR PARAELIMINAR EL AGUA ACUMULADA.
RÉSERVOIR DE VIDANGE QUOTIDIEN OU APRÈS TOUTES LES 4 HEURES D'UTILISATION.
AVERTISSEMENT
L'HABILLAGE DE CONDENSATION PEUT CAUSER LA CORROSION À L'INTÉRIEUR DU RÉSERVOIR AYANT
POUR RÉSULTAT L'ÉCHEC DE RÉSERVOIR. VOIR LE MANUEL POUR DES PROCÉDURES D'INSPECTION. À LA VALVE
OUVERTE DE RÉSERVOIR DE VIDANGE LENTEMENT ET AU COMPRESSEUR D'INCLINAISON À L'EAU ACCUMULÉE VIDE.
DO NOT OPERATE IN UPRIGHT
no opere la her
r a mienta en
ne pas faire fon c tionner en position
POSITION. UPRIGHT POSITION
posición ver ti c al. Só l o
ver ti c al e. La position ver ti c ale est
IS FOR STORAGE ONLY.
al macene en es ta posición.
rése r vée au s t oc kage uniquemen t.
GLOSSArY
CFM: Cubic feet per minute.
sCFM: Standard cubic feet per minute; a unit of measure of air
delivery.
PsI: Pounds per square inch; a unit of measure of pressure.
kPa (kilopascal): Metric pressure measurement. 1 kilopascal
equal 1000 pascals.
Code Certification: Products that bear one or more of the
following marks: UL, CUL, ETL, CETL, have been evaluated by
OSHA certified independent safety laboratories and meet the
applicable Standards for Safety.
Cut-In Pressure: While the motor is off, air tank pressure drops
WALT for a free
e
when accessory is used. When the tank pressure drops to a certain
low level the motor will restart automatically. The low pressure at
which the motor automatically restarts is called cut-in pressure.
WARNING
HOT SURFACES
ADVERTENCIA
Cut-Out Pressure: When an air compressor is turned on and
SUPERFICIES CALIENTES
AVERTISSEMENT
SURFACES CHAUDES
begins to run, air pressure in the air tank begins to build. It builds
to a certain high pressure before the motor automatically shuts
off, protecting your air tank from pressure higher than its capacity.
The high pressure at which the motor shuts off is called cut-out
pressure.
Branch Circuit: The circuit carrying electricity from electrical panel
to outlet.
WARNING
DO NOT ADJUST FACTORY SETTINGS.
TO REDUCE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER.
Pressure controls set at factory for
maximum safe operation.
Duty Cycle: This air compressor pump is capable of running
ADVERTENCIA
NO HAGA CAMBIOS EN LOS AJUSTES
DE FÁBRICA. NO RETIRE LA TAPA PARA
REDUCIR EL RIESGO DE CHOQUE ELÉCTRICO.
Los controles de presión se ajustan en la
continuously. However, to prolong the life of your air compressor,
fábrica para máxima seguridad en la operación.
AVERTISSEMENT
NE PAS MODIFIER LES RÉGLAGES DE L'USINE. NE PAS
RETIRER LE COUVERCLE AFIN DE RÉDUIRE LES RISQUES
it is recommended that a 50%-75% average duty cycle be
DE CHOCS ÉLECTRIQUES.
La pression est réglée en usine a n de maximiser la
sécurité de fonctionnement.
maintained; that is, the air compressor pump should not run more
than 30-45 minutes in any given hour.
16
Publicité
