Backlight; Hold' Function; Torch Function - VOLTCRAFT 2274366 Notice D'emploi

b) Backlight
• The current clamp features a backlight so that the LC display (5) can be read more easily.
• Switch on the backlight by pressing the HOLD/
2 seconds to switch to low intensity lighting.
• Press and hold the HOLD/
• Press and hold the HOLD/
switching cycle is complete.
c) 'HOLD' function
• The HOLD function retains the currently displayed measured value on the LC display (5) so
that it can be read off later or logged.
• To switch the HOLD function on, press the HOLD/
with a beep and
• To switch the HOLD function off, press the HOLD/
(3) or change the measuring function by pressing the SELECTbutton (9).
d) Torch function
The torch function only works when the measuring device is switched on.
• Press the button (2) to switch the LED torch on the back of the measuring device on.
• Press the button (2) to switch the LED torch on the back of the measuring device off.
56
button again to switch to the backlight with high light intensity.
button a third time to switch the backlight off. The backlight
(O) will be shown on the display.
button (4) and holding it for approx.
button (4); this action will be confirmed
button again, actuate the rotary switch