VOLTCRAFT 2274366 Notice D'emploi page 48

48
• After a successful zero adjustment, route the individual
conductor that is to be measured into the current
clamp. Position the conductor along the two direction
lines at the bottom end of the U-shaped current clamp.
• The measured current is shown on the LC display.
• A positive or negative symbol is also displayed with the
display value, depending on the direction of insertion.
A minus '-' symbol before the measured
value indicates that the current is flowing in
the opposite direction (or the current clamp
terminals have been reversed).
• Do not measure currents above 200 A. Continuous
beeps will be emitted if the measurement range is
exceeded (200 A).
• After completing the measurement, remove the current
clamp from the measured object and switch the
product off.