Orved bright 315 Mode D'emploi Et D'entretien page 68

MAINTENANCE AND TEChNICAl SUPPORT
4) Using a hexagon wrench, undo the screws of the element at both ends of the bar (Fig. 4).
5) Remove the old element making sure to keep the two brass pressers and their springs in place (Fig. 5).
Fig. 4
6) Attach the new element to one of the two ends of the sealing bar, fastening it on with the screw you had undone
previously (Fig. 6).
7) Insert the other end of the element on the opposite side, pulling it through
the bottom hole. Tighten the element by winding it round with long nose
pliers (Fig. 7).
68
Rev. 05 - 04/2018 - Cod. 1500458 - Instruction manual for vacuum chamber packaging machines with digital control panel "Serie Bright"
Fig. 6
Fig. 7
Fig. 5