Orved bright 315 Mode D'emploi Et D'entretien page 49

2) Select the NO STOP jARS program and set the sealing value:
PhASE DESCRIPTION
1 Enter "containers program" mode "by pressing the PUMP key.
2 Select the JARS NO STOP mode with the SEl selection key.
Sealing programming: press the PROG button for 3 seconds.
3
The display shows the programmed value.
4
Change the value. A number of LEDs proportional to the value switch on/off.
5 Confirm the value with PROG.
3) Position the bag. The opening of the bag must protrude about 2 cm with respect to the sealing bar
4) Insert the "Easy" accessory
5) Start-up the cycle by lowering the lid.
6) Interrupting the cycle. The machine immediately stops the cycle and the chamber is decompressed
when the "STOP" button is pressed at any time.
The lid is opened automatically.
The machine returns to the set program.
Rev. 05 - 04/2018 - Cod. 1500458 - Instruction manual for vacuum chamber packaging machines with digital control panel "Serie Bright"
B . Place the accessory suitable for your model between the bag and the container.
C
2
cm
D
OPERATION
KEy
D
.
B
A
49