Kemper SmartFil Notice D'utilisation page 56

NOTE
The signal horn sounds if the volume flow falls below the flow rate minimum.
Please also refer to the information contained in the "Changing Filters" chapter for this
product version.
WARNING
Cleaning the filter inserts is not permitted. This inevitably leads to damage to the filter
medium, meaning the filter ceases to function and hazardous substances enter the air.
During the work described in the following section, pay particular attention to the seal
on the main filter. Only an undamaged seal allows the product to achieve a high filter
efficiency. Main filters with a damaged seal must therefore be replaced every time.
NOTE
Refer to the "Installation" and "Use" chapters for the following steps.
• Only use original replacement filters, because they guarantee the necessary filter
efficiency and are matched to the product and its performance characteristics. Switch
the product off at the switch.
1502818-00
Fig. 12: Filter replacement – Removing the filter element
- 56 -
EN