Milk Heating Function - Unold Latte Bricco Notice D'utilisation

5. Replace the lid. Note: a safety function pre-
vents the appliance being switched on if the
lid does not sit properly. In this case, the
button only flashes, but the appliance does
not start. Press the lid on to the appliance
until it clicks into place.
6. If you want to prepare hot milk froth, press
button A.
7. If you want to prepare cold milk froth, press
button B.
8. If you want to prepare a salad dressing, also
press button B. Remember that you can
B

Milk heating function

1. Prepare the appliance as described in
„Frothing milk".
2. Remove the milk frother accessory from the
agitator.
3. Add at least 100 ml milk (min. mark), but
no more than 330 ml (top max. mark) to the
jug. Never add more milk, since the milk
may overflow from the jug.
A
only prepare cold salad dressings with the
appliance.
9. The corresponding indicator light shows that
the appliance has started frothing the milk.
10. The milk froth is ready in about 120 seconds
and the appliance stops automatically.
11. If you wish to interrupt the process, press
the selected button again.
12. Press the locking button and remove the lid
from the appliance.
13. You can now pour or spoon the milk froth
into a container.
14. If you wish to froth more milk, allow the
appliance to cool for 2 to 4 minutes. Then
clean the jug as described in Cleaning and
Care.
Important: Make sure that there is
no milk residue in the jug to prevent
germs forming. clean the appliance
after every use.
4. Replace the lid. Note: a safety function pre-
vents the appliance being switched on if the
lid does not sit properly. In this case, the
button only flashes, but the appliance does
not start. Press the lid on to the appliance
until it clicks into place.
5. To heat milk, press button A.
6. The indicator light shows that the appliance
starts heating the milk.
7. If you wish to interrupt the process, press
the selected button again.
8. Press the locking button and remove the lid
from the appliance.
9. You can now pour the milk into a container.
10. If you wish to heat more milk, allow the
appliance to cool for 2 to 4 minutes. Then
clean the jug as described in Cleaning and
Care.
11. Tip: When you are finished heating milk,
replace the milk frother accessory so that it
doesn't get lost.
Important: Make sure that there is
no milk residue in the jug to prevent
germs forming. clean the appliance
after every use.!
21