Radio Operations; Listening To The Radio - JVC KD-AR600 Manuel D'instructions

RADIO OPERATIONS

Listening to the radio

You can use either automatic searching or manual
searching to tune in to a particular station.
Searching a station automatically:
Auto search
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM 1
Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Start searching for a station.
To search stations of lower frequencies
When a station is received, searching stops.
10
7
FM 2 FM 3 A M
Selected band appears.
To search stations of
higher frequencies
To stop searching before a station is
received, press the same button you have
pressed for searching.
Searching a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Press and hold ¢
until "M" (manual) starts flashing on
the display.
FM 3 A M
or 4