Assigning Names To The Sources - JVC KD-AR600 Manuel D'instructions

Assigning names to the sources

You can assign names to station frequencies and
CDs (both in this unit and in the CD changer only
for KD-AR600).
After assigning a name, it will appear on the
display when you select the source.
Maximum number of
Sources
characters
Station frequencies Up to 8 characters (up to
30 station frequencies
including both FM and AM)
CDs* Up to 32 characters (up to
40 discs)
* You cannot assign a name to a CD Text or an MP3/
WMA disc.
1
Select a source you want to assign a
name to.
(For KD-AR600)
When you select a source, the power
automatically comes on.
2
While pressing DISP (display), press
and hold SEL (select) for more than
2 seconds.
Ex.: When you select CD as the source
3
4
5
6
(For KD-SC500)
To erase the input characters
To erase all the characters at a time, press and
hold DISP (display) for more than 1 second as
described in the procedure above.
Available characters
Notes:
• When you try to assign a name to the 41st disc,
• When the CD changer is connected, you can assign
Select a character.
• See below for available
Move the cursor to the next
(or previous) character position.
Repeat steps 3 and 4 until you
finish entering the name.
Finish the procedure while the last
selected character is flashing.
A B C D E
K L M N O
U V W X Y
4 5 6 7 8
space
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit (only for KD-AR600).
characters.
F G H I J
P Q R S T
0 1 2 3
Z
9 – <
/ >
29