Fault Correction; Replacement Parts - Franke PROTRONIC AQUA502 Notice De Montage Et De Mise En Service

16. Fault Correction

Fault
Water does not flow
Water flows conti-
nuously
Water flow too weak
Water flow too large
If you are unable to correct a fault or if the fault is not described in the fault correction
section, please inform our customer service department!

17. Replacement Parts

Bezeichnung
1 Pushbutton flusher with
hose and
solenoid valve . . . . . . . . . . . . . 2000105801
1a Complete upper section . . . . . . . . 2000104418
1b Plastic hose
Specify length in meters. . . . . . 2000104803
2 Electronic module M2* . . . . . . . . . 84-100-17.109
3 Frame with profile seal . . . . . . . . . 2000105819
4 Opto-sensor . . . . . . . . . . . . . . . . . 2000105815
5 Cover plate . . . . . . . . . . . . . . . . . . 2000109495
* When placing an order, please specify the
fittings-ID!
The fittings-ID is located on the side of the
electronic module.
Cause
– Water supply interrupted
– Water flow regulator closed
– Solenoid valve faulty
– Opto-sensor faulty
– Electronic module defective
– Solenoid valve dirty
– Solenoid valve faulty
– Water volume regulator not fully
opened
– Supply pressure too low
– Flush volume adjustment incorrect
– Flush volume adjustment incorrect
Best.-Nr.
Remedy
➯ Restore it
➯ Open it
➯ Replace it
➯ Replace it
➯ Replace it
➯ Clean it
➯ Replace it
➯ Open it
➯ Check it
➯ Adjust it
➯ Adjust it
Zubehör
ECC function controller
with Ethernet connection (60 W)
ECC2 . . . . . . . . . . . . . . . . . . . .2000108123
Power supply (12 W) . . . . . . . . . . .2000100375
Power supply (60 W) . . . . . . . . . . .2000101174
System line for continuous operation in water,
halogen free 100 m . . . . . . . . . .2000104272
halogen free 25 m . . . . . . . . . . .2000104274
System line,
not halogen-free, 100 m . . . . . .2000100801
not halogen-free, 25 m . . . . . . .2000100852
Best.-Nr.
9