Checking And Replacing The Transmission Oil - IBEA IB 562 Manuel D'instructions

G) CHECKING AND REPLACING THE TRANSMISSION OIL
Check the transmission oil level using the relative oil level screw (fig. 11 ref. A).
If oil leaks out upon removal of this screw then there is enough of it in the transmission.
If not, remove the filling cap shown in fig. 11 ref. A, then top up with OIL SAE 90.
The oil should be replaced after the first 20 hours of use and after this every 100 working
hours.
Remove the drainage cap shown in figure 11 ( ref. B), and allow all the oil to run out.
After refitting the drainage cap, fill the transmission from the filling cap with SAE90 transmission
oil. (0,550 kg)
Refit the lid securely to prevent aby leakage of oil.
Figure 11
- 62 -