IBEA IB 562 Manuel D'instructions page 68

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGINE
FAULT
Engine sluggish at switch on
Poor power
Engine stalls
Exhaust fumes dark
Engine emits black smoke and
power is poor
Exhaust fumes bluish
Silencer becomes red through
overheating
For any problems not easily resolved or in case of doubt you are advised to contact your
dealer.
CAUSE
1.
accelerator not in start-up
position
2.
Choke not closed
3.
Petrol does not arrive
4.
Air bubbles or water inside
the petrol lines
5.
Thick oil prevents rotation
6.
Winding
or
mechanism faulty
7.
Spark
plug
in
condition
1. No fuel
2. Air filter blocked
3. Elastic bands worn
1. no fuel
2. feed cock shut off
1.
low grade fuel
2.
too much engine oil
1. air filter blocked
2. choke not fully opened
1. too much engine oil
2. Elastic bands worn
1. Air filter blocked
2. Inside
of
self-winding
starter blocked with grass
cuttings
- 68 -
MEASURES TO BE TAKEN
1. move the accelerator to the
intermediate position
2. Close the choke when cold.
3. Check the fuel tank and
remove
any
sediment. Make sure that
the feed cock is open.
4. Check the lines and bands.
Repair
or
damaged
5. Use oil with a viscosity
suited to the temperature
start
6. Replace winding or start
mechanism
poor
7. Clean or replace spark
plug. Adjust the distance
between the electrodes.
1. Refill the tank
2. clean air filter
3. replace elastic bands
1. Refill tank with petrol
2. open feed cock
1. replace with high grade fuel
2. restore engine oil to correct
level
1.
clean air filter
2.
open the choke completely
1. restore engine oil to correct
level
2. replace elastic bands
1. clean air filter
2. clean self-winding starter
housing
water
or
replace
if

Publicité

Chapitres

Table des Matières
loading

Table des Matières